Cable connections are:
    1. Motor (Orange=positive monitor) to DAQ pin 11 (AI0+)
    2. Motor (Gray=negative monitor) to DAQ pin 12 (AI0-)
    3. Motor (Black=Ground) to ground on power supply 
    4. Motor (Red=Positive) to 25V positive on power supply
Run LabVIEW 2015 - 32 bit
Double check VISA resource # for Voltage Source
Double check device name of USB DAQ
 (these both may be different on each machine)
If there is a load connected,
    1. Set Tolerance to 5
    2. Set Point should be lower, e.g. 500 instead of 1000
Ignore PID Control Toggle